Breast pumps
Guide to breast pumps
The seal depends on contact between the rim and the skin. A thin layer of water-based lubricant on the rim seals far better than any extra effort with the pump, and lets you use less suction for the same effect.
Apply suction gradually, one pump at a time, waiting a few seconds between each. Five to ten minutes per cup is more than enough, and several short sessions make more sense than one long one.
There are only a few things to avoid, and you should remember them all: don't keep going if you feel pain, don't fall asleep with the cups on, don't use them on irritated or freshly shaved skin, and stop if the nipple turns very dark or loses sensation. If you have circulation problems, are pregnant or breastfeeding, talk to your doctor first. If you notice lumps, discharge or breast pain, have a specialist assess it.
How long should you keep the cup on?
Five to ten minutes at a time is more than enough, and you can repeat after a break. Keeping the cup on much longer doesn't increase anything and makes bruising more likely. Remove it earlier anyway if you feel numbness, if the colour becomes very dark or if the sensation stops being pleasant. Never fall asleep with the cups on.
Does it hurt?
It shouldn't. What you should feel is a firm but bearable pull, together with warmth and heightened sensitivity. Real pain means the suction is too strong or the rim is pinching: open the valve, remove the cup and start again with less suction or a different diameter. Pushing through the pain is the quickest way to end the evening early.
Does the increase in size last?
No. The effect is temporary and linked to increased blood flow: the heightened sensitivity lasts for the session, the slight swelling for a few hours, then everything returns to normal. No pump changes shape or size permanently, and any promise to that effect is unrealistic. What they offer is a different sensation during play.
Do you need lubricant?
It helps a lot. A thin layer of water-based lubricant on the rim of the cup improves the seal, lets you use less suction for the same effect and makes removal less abrupt. There's no need to fill the cup: just wet the rim. If the seal is still poor, the diameter is probably not the right one for your anatomy.
How do I clean them?
After each use, wash the cups and seals with lukewarm water and mild soap or a toy cleaner, taking apart any parts that come off. Rinse the tubes and leave them to drain, because water left inside is the typical problem with these sets. Dry everything before putting it away, away from heat, which warps the plastic and hardens the rims.
