Sex grinders
Guide to sex grinders
Both ways of using it coexist in the same category. The first is squeezing: you hold the block in your hand and close your grip, adjusting the pressure as you like. The second is resting it down: the piece sits on a stable surface and you move on top of it hands-free. Wide bases are there to keep it still under your weight.
Solid silicone has two practical consequences. The first is silence: with no motor and no air chambers, they make no noise. The second is cleaning: no blind channel to empty, no insert to turn inside out, and it dries in a few minutes.
The usual silicone rules still apply. Use a water-based lubricant, never a silicone-based one, as it would damage the surface. Lukewarm water and mild soap after every use, paying attention to the gaps between the ridges. Dry with a cloth and then let it air-dry. Store it away from light, in its own pouch.
How do you use a sex grinder?
In two ways. Hold it in your hand and tighten your grip around it, so you can control the pressure with every stroke and change the intensity in real time. Or place it on a stable surface, on a pillow or the edge of the bed, and move on top of it hands-free. Either way, you need water-based lubricant on the contact surface, because dry silicone drags on the skin and quickly causes irritation.
Are they noisy?
Hardly at all. They have no motor, no batteries and no air chambers that could create suction noise, so they're among the quietest items in the category. The only audible sound is from the lubricant, which you can reduce by using a measured amount. If you live in a flat with thin walls, it's a real difference compared with any motorised model.
Are they easier to clean than a masturbator with a channel?
Much easier. With no closed-end channel to empty and no inserts to turn inside out, cleaning simply means washing a surface: lukewarm water, mild soap, attention between the ridges where lubricant collects, a rinse and a cloth. Drying takes minutes instead of hours, and there's no problem of trapped moisture, which ruins channel masturbators that haven't been dried properly.
Which lubricant do I need?
Water-based, always. The body is silicone, and with repeated contact a silicone lubricant dulls and degrades the surface. You need a moderate amount, spread over the contact area: too much makes the toy slip and you lose your grip, too little creates friction. If it becomes less slippery during use, add a thin layer rather than pressing harder.
Are they suitable for beginners?
Yes, because there's nothing to insert and nothing to adjust: the intensity depends only on how much pressure you apply, so you can start very gently and build up. There are no batteries to charge or programmes to figure out, and the toy doesn't impose a rhythm. It's also a good format if you've found motorised models too intense and want something you can fully control.
